Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Kundendienti
15.2 Overview of All Files in RAM
SERVICE MANUAL TNC 407/415
Issue: 01.09.1995
Page 65
File File Extension File Selection
Directly via Code Number
NC programs HEIDENHAIN language .H x
NC programs IS0 .I x
Tool files .T x
Pallet tables .P x
Datum tables .D x
Text files .A x
Machine parameters .MP x
Compensation value list .KOR x
PLC program .PLC x
Error messages 1. language .ERl x
Error messages English .ERE x
Dialogs 1. language .DIl x
Dialogs English .DIE x
Text files .A x
Additional information on the files and programs is provided by letters in the status field:
E: The file/program has been selected in the PROGRAMMING mode.
S: The file/program has been selected and activated in the TEST RUN mode.
M: The file/program has been selected and activated in either PROGRAM RUN/ FULL SEQUENCE
or in PROGRAM RUN/SINGLE BLOCK.
P: The file/program is protected against erasing and editing.
IN:The file/program was programmed in Inch.
W:The file/program was not completely transferred to the external memory and thus is no longer
available.
15.3 External Data Output
Connect the external data medium (ME, FE or other peripheral unit, e.g. personal computer with
HEIDENHAIN data transfer software) to the TNC.
Prepare the external data medium for data transfer:
press m , and a at the ME
press m at the FE.
Select the operating mode, the Baud rate and the interface assignment (see sections 14.1
and 14.2) at the TNC.
The ME (Magnetic Tape Unit) is not very suitable as an external data medium,
as only one file can be stored on one side of a cassette.