Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Kundendienst<br />
HEIDENHAIN<br />
<strong>DR</strong> <strong>JOHANNES</strong> HEIDENHAIN GmbH<br />
D~83292T,aunreut~~-‘O8669)31~0<br />
14.5.2 Error Messages at the ME<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
01.09.1995<br />
Page 60<br />
In the ME the electronics is tested, and the external operating conditions are checked. If an error is<br />
detected, the lamps of the operating mode display start blinking. In the following table the error types<br />
are listed:<br />
0 LED off * LED blinking<br />
Indicator Lamp 1 Error Message<br />
0004<br />
0000<br />
oo*o<br />
0000<br />
oo**<br />
0000<br />
o*oo<br />
0000<br />
o*o*<br />
0000<br />
o**o<br />
0000<br />
4404<br />
0000<br />
4444<br />
0000<br />
0+**<br />
0000<br />
Faulty data during transfer<br />
No cassette inserted<br />
Write-enable plug in cassette missing<br />
Wrong operating mode selected<br />
Data of magnetic tape faulty<br />
Magnetic tape blank<br />
Errors in ME electronics<br />
End of tape<br />
Peripheral unit not connected<br />
***0 Data transfer between <strong>TNC</strong> and ME/peripheral unit was interrupted with RI<br />
0000<br />
By pressing ’ the error messages can be cleared.<br />
20885001