Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Kundendienst<br />
HEIDENHAIN<br />
<strong>DR</strong> <strong>JOHANNES</strong> HElDENHAlN GrnbH<br />
D-83292Traunreut.~(O8669)31-0<br />
c) Loosen the 4 mounting screws on the logic unit<br />
66200 KD 6075<br />
d) Remove the old logic unit and insert the new one.<br />
19.23 Mounting of the Logic Unit<br />
The logic unit is mounted in the reverse order that is was dismounted:<br />
a) Insert the logic unit and secure it.<br />
b) Engage connectors.<br />
Observe that no connectors are switched!<br />
c) Switch on the main switch.<br />
d) Read in the machine tool data that have been backed up before the exchange<br />
(machine parameters, PLC program, NC programs and tables).<br />
e) Enter preset values and supplementary operating modes from the table in<br />
section 19.1.5 (before ref. mark traverse).<br />
f) Offset adjustment with code number (see section 16.5).<br />
Exchange is now finished<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
Issue: 01.09.1995<br />
Page 94