Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
Configuration of the handwheel 7640* Š Š I03 I03 - - 0 = machine with electronic handwheel
1 = machine without electronic handwheel
Configuration of the handwheel
- - 03 03 Š Š 0 = no handwheel connected
7640*
- - 03 03 Š Š 1 = HR 330 (all keys via NC)
- - 03 03 Š Š
- - - - Š Š
- - - - Š Š
- - - - Š Š
- - - - - 04
1)
2 = HR 130, HR 330 (all keys via NC) 2)
3 = HR 330 rapid traverse key: PLC I 162
plus key: PLC I 160
minus key: PLC I 161
4 = HR 332; evaluation of keys and LEDs
depends on MP7645.0
5 = HRA 110, multi-axis handwheel
(3 x HR 150)
6 = HRA 410, evaluation of keys and LEDs
depends on MP7645.0
Entry of interpolation factor 7641 - - - - Š Š 0 = at keyboard
1 = via PLC module 9036
* accessible via code number 123
1) axis switchover with handwheel
2) axis switchover with handwheel or keyboard
3) If the HR 410 does not receive any initializing parameters (MP 7645.x)
it automatically switches to HR 332 mode (MP 7640 = 4).
RH
1.0 TNC 407/415 Machine Parameters MP 7640 - MP 7641 08.05.95 10.2 58
0
0
0