Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
II HEIDENHAIN<br />
<strong>DR</strong> .JOHmwlES HUDENHAIN GrnbH<br />
D-83292 Tla”nle”t~ SB (08669) 31-o<br />
Kundendienst<br />
16.5.3 Offset Adjustment at the Servo-Amplifier<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
Issue: 01.09.1995<br />
Page 78<br />
Check/adjust the following machine parameters. (Note down the original values before changing.)<br />
1080.0 0<br />
1080.1 0<br />
Entry Function Original Value<br />
VZ3lUf? I<br />
1080.2 0 I<br />
1080.3<br />
0 Integral factor<br />
1220<br />
0<br />
Cycle time for automatic offset<br />
adjustment<br />
1390 0 Feed precontrol ON<br />
in the automatic operating modes<br />
1510.0 >=I<br />
1510.1 >=I<br />
1510.2 >=I<br />
1510.3 >=I KV factor for feed precontrol<br />
7290 0 1 Display step = 1 pm<br />
Switch position display to LAG (display of servo lag) (see sec. 16.3).<br />
Clear the offset memory with the code number 75368 (see sec. 16.5.1).<br />
Adjust the offset at the servo-amplifier until the values of the individual axes are zero<br />
or oscillate symmetrically about zero.<br />
- Reset the machine parameter values and the position display to their original values.
Change language