Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
HEIDENHAIN<br />
13.2 Error Messages<br />
TOUCH POINT INACCESSIBLE<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
01.09.1995<br />
Page 53<br />
After the start of a probing function, the scanning point was not reached within the<br />
measuring range defined in the machine parameter MP6130.<br />
1 EXCHANGE TOUCH PROBE BATTERY 1<br />
The battery voltage of the touch probe system with infrared transmission is below the<br />
minimum value.<br />
STYLUS ALREADY IN CONTACT<br />
- The stylus was already deflected when the probing function was started.<br />
I PROBE SYSTEM NOT READY<br />
The infrared transmission between the “Touch Probe” and the “Transmitter/Receiver<br />
Unit” is faulty (e.g. caused by contamination) or interrupted. The two windows of the<br />
touch probe system must be oriented to the transmitter/receiver unit.<br />
The battery is dead.<br />
13.2.2 Error Messages during Digitizing of 3D-Contours<br />
WRONG AXIS PROGRAMMED<br />
The touch probe axis in the scanning cycle RANGE is not identical to the calibrated<br />
touch probe axis.<br />
FAULTY RANGE DATA<br />
- A MIN coordinate value in the scanning cycle RANGE is equal to or larger than the<br />
corresponding MAX coordinate value.<br />
- One or more coordinates are beyond the limit switch range of the scanning cycle RANGE.<br />
A scanning cycle RANGE was already defined when the scanning cycles MEANDER or<br />
CONTOUR LINES were called.<br />
MIRRORING NOT PERMITTED<br />
ROTATION NOT PERMIlTED<br />
SCALING FACTOR NOT PERMIlTED<br />
Mirroring, rotation or scaling factor were active when the scanning cycles RANGE,<br />
MEANDER or CONTOUR LINES were called.