Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
Datum in datum table 7475 - - - - Š Š 0 = datum point is workpiece datum
0
1 = datum point is machine datum
Output of tool number or pocket
number
0 to 6
with TOOL CALL block 7480.0 Š Š Š Š Š Š 0 = no output
2
Š Š Š Š Š Š 1 = output of tool number only when
tool number changes (W262)
Š Š Š Š Š Š 2 = output of tool number with every
TOOL CALL (W262)
Š Š Š Š Š Š 3 = output of pocket number (W262) and
tool number (W264) only when tool
number changes
- - 05 04 Š Š 4 = output of pocket number (W262) and tool
number (W264) with every TOOL CALL
- - - - 08 Š 5 = output of pocket number (W262) and tool
number (W264); pocket table does not
change.
- - - - 08 Š 6 = output of pocket number (W264) with
every TOOL CALL; pocket table does not
change.
RH
1.0 TNC 407/415 Machine Parameters MP 7475 - MP 7480.0 16.01.95 10.2 55