Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Kundendienst<br />
12.3 Error Messages<br />
HANDWHEEL ?<br />
Data transfer (cable) has been interrupted.<br />
HANDWHEEL DEFECTIVE 1<br />
The light unit in the electronic handwheel is not emitting enough light,<br />
with the result that the signals in the handwheel are too small. An error<br />
signal is sent over the serial interface of the handwheel.<br />
HANDWHEEL NOT READY<br />
X<br />
X= A:<br />
B:<br />
CY:<br />
D:<br />
E:<br />
F:<br />
G:<br />
H:<br />
I:<br />
J:<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
01.09.1995<br />
Paae 51.2<br />
No manual handwheel connected<br />
Identification code of the manual handwheel does not match MP7640<br />
Contamination, Y = axis identification (only for multi-axis handwheell<br />
Error during receipt of data<br />
Incorrect BCC check sum received<br />
<strong>Manual</strong> handwheel outputs “Wrong identification received”<br />
<strong>Manual</strong> handwheel outputs ‘Incorrect BBC check sum received”<br />
<strong>Manual</strong> handwheel outputs “Transmission error’<br />
<strong>Manual</strong> handwheel outputs “Wrong number of initialising parameter received”<br />
<strong>Manual</strong> handwheel outputs “Wrong value of initialising parameter received”
Change language