Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

3D-Touch Probe (General Parameters)
Function MP A B C D E F Input AE-6
No. Bit Entry Value
Selection of touch trigger probe 6010* Š Š Š Š Š Š 0 = transmission via cable (TS 120)
1 = infrared transmission (TS 510)
Probing feed rate 6120* Š Š Š Š Š Š 10 to 3 000 [mm/min] 80
Maximum measuring range 6130* Š Š 04 04 Š Š 0.001 to 99 999.9999 [mm] 1
Safety clearance over measuring
point for automatic measurement
6140* Š Š Š Š Š Š 0.001 to 99 999.9999 [mm] 1
Rapid traverse for probe cycle 6150* Š Š Š Š Š Š 10 to 10 000 [mm/min] 2000
M-function for rotating the
spindle by 180° to compensate the
center misalignment of the stylus
* accessible via code number 123
6160* - - - - Š Š -1 = oriented spindle stop via NC
0 = function inactive
1 to 88 = number of M-function for oriented
spindle stop via PLC
RH
1.0 TNC 407/415 Machine Parameters MP 6010 - MP 6160 08.05.95 10.2 34
0
0