Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
HEIDENHAIN<br />
<strong>DR</strong> .<strong>JOHANNES</strong> HEIDENHAIN GnlbH<br />
D~~3292TIEiunre"t-~(08669)31-0 SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
01.09.1995<br />
Kundendienst Page 59<br />
14.5. Error Messages<br />
14.5.1 Error Messages at the <strong>TNC</strong> in the ME-Mode<br />
WRONG OPERATING MODE<br />
- The wrong operating mode no operating mode was selected on the external data medium<br />
r---<br />
WRONG PROGRAM DATA<br />
Wrong program data have been detected during data transfer. The control attempted<br />
three times to read the data from the magnetic tape before interrupting the process.<br />
DATA MEDIUM MISSING<br />
No cassette has been inserted into the drive.<br />
DATA MEDIUM EMPTY<br />
No programs are stored on the data medium (cassette).<br />
DATA MEDIUM WRITE-PROTECTED 1<br />
The write-enable plug on the cassette is missing<br />
I PROGRAM INCOMPLETE I<br />
- Data transfer was interrupted before the program was transferred completely.<br />
EXT. INPUT/OUTPUT NOT READY<br />
The DSR-signal is missing at the <strong>TNC</strong>.<br />
ME not connected<br />
- Defective or wrong transfer cable<br />
Wrong interface assignment<br />
ME: TAPE END<br />
The cassette is full. To continue data transfer, turn over or exchange the cassette.