Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Kundendienst
HEIDENHAIN
DR JOHANNES HEIDENHAlNGmbH
D-83292Tra”nre”t .ey(o&?669) 31-o
14.5.3 Error Messages at the FE in the ME-Mode
In the ME-mode, errors are displayed by blinking indicator lamps (LEDs).
SERVICE MANUAL TNC 407/415
01.09.1995
Paqe 61
0 LED off 0 LEDon + LED blinking
Indicator Lamp Error Massage
ooo*
o*oo
ooo*
o*oo
*ooa
*ooo
*oo*
*ooo
O*@
0000
*0**
0000
*ooo
ooeo
*0.*
0000
*oo*
00.0
oo*o
ooo
00..
*ooo
0000
*ooo
oo**
*ooo
ooo*
*o*o
ooo*
oo*o
o*o*
oo*o
o*o*
oo*o
ooo*
oo*o
oo**
0000
oo*e
0000
Disk missing or error in the ME electronics
Disk cannot be formatted, as it is currently being used
Disk missing or not formatted
Disk cannot be copied, as a read/write process is active
External unit not ready or not connected
Disk missing or not formatted
Disk missing or not formatted or no program available
Program cannot be output, as a transfer is active via the TNC interface
Program cannot be output, as a transfer is active via the PRT interface
External unit not ready or not formatted
Disk missing or not formatted
Disk missing or not formatted
Program cannot be output, as a transfer is active via the TNC interface
Program cannot be output, as a transfer is active via the PRT interface
External unit not ready or not connected
Disk missing or error in the ME electronics
Table of contents cannot be output, as a transfer is active via the PRT interface
No interface coupling possible, as a transfer is active via the TNC interface
No interface coupling possible, as a transfer is active via the PRT interface
External unit not ready or not connected
By pressing a the error messages can be cleared.