Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
Initalizing parameters for the
handwheel
Allocation of the 3rd handwheel via axis
selector switch (MP7640 = 5)
7645.0 0
- - - - Š Š +0 = position 1 (left stop) → Z axis
position 2 → IV. axis
position 3 → V. axis
+1 = position 1 → X axis
position 2 → Y axis
position 3 → Z axis
position 4 → IV. axis
position 5 → V. axis
1
+2 = position 3 → Z axis
position 4 → IV. axis
position 5 → V. axis
2 - 7
reserved
Evaluation of keys and LEDs on HR332
7645.0 - - - - Š Š HR 332
(MP7640 = 4)
0 = keys X, Y, Z, IV and their LEDs are
HR 410 in HR 332 mode (MP 7640 = 4)
evaluated by NC
remaining keys: PLC I 164 to I 170
remaining LEDs: PLC O 100 to O 106
1 = keys: PLC I 160 to I 171
LEDs: PLC O 96 to O 107
HR 410
0 = keys X, Y, Z, IV and their LEDs are
evaluated by NC
remaining keys: PLC I 164 to I 171
remaining LEDs: PLC O 100 to O 107
1 = keys: PLC I 160 to I 171
LEDs: PLC O 96 to O 107
HR 410 in HR 410 mode (MP 7640 = 6) 7645.0 - - - - Š Š 0 = keys X, Y, Z, IV, V, actl. value transfer and
their LEDs are evaluated by NC
remaining keys: PLC I 168 to I 175
remaining LEDs: PLC O 100 to O 111
1 = keys: PLC I 168 to I 175
LEDs: PLC O 96 to O 111
RH
1.0 TNC 407/415 Machine Parameters MP 7645.0 08.05.95 10.2 59
0
0
0