Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
Issue: 01.09.1995<br />
Page 70.1<br />
* In the interface modes FEZ, EXTI and EXT2 the name of the ASCII file must be entered manually,<br />
as it cannot be displayed by the <strong>TNC</strong>.<br />
** The file TO0L.T always contains the tool table that is read by the <strong>TNC</strong>. TO0L.T cannot be edited,<br />
read out or downloaded. In the <strong>TNC</strong> several files xxx.T may be stored. The tool table 1xxx.T) the<br />
<strong>TNC</strong> is supposed to read must be copied into TO0L.T. I.e. after downloading the files xxx.T, the<br />
current tool table still needs to be copied into TO0L.T (see section 15.3.1).<br />
Copying the file xxx.T into TO0L.T<br />
Switch <strong>TNC</strong> to operating mode EDITING<br />
(key on VDU)<br />
Display of file names<br />
Soft key >SHOW ALL< to display all file types<br />
Press arrow key at the VDU to switch the soft-key<br />
row to the file type display<br />
Soft key >SHOW .T< to display the tool tables<br />
Press arrow key to switch back the soft-key row<br />
If necessary: select file xxx.T with arrow key<br />
Soft key >COPY ABC + XYZ<<br />
Enter file name TOOL, acknowledge with ENT<br />
Soft key >END< to switch the <strong>TNC</strong> to the operating<br />
mode EDITING