Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Digitizing with 3D-Touch Probe
Function MP A B C D E F Input AE-6
No. Bit Entry Value
Number of oscillations in normal
direction
Lubrication of touch probe axis
6210 - - Š Š Š Š 0 to 65.535 [1/sec] 0
• displacement for lubrication at the end
of a line
6220 - - - - - Š 0.000 to 999.999 [mm] 0
• time intervals for lubrication 6221 - - - - - Š 0 to 65 535 [min] 0
Feed rate in normal direction 6230 - - Š Š Š Š 0 to 1 000 [mm/min] 0
Maximum deflection of the stylus
Output of M90 on NC blocks of
6240 - - Š Š Š Š 0 to 10 [mm] 0
digitized data
Rounding the decimal places
6260 - - Š Š Š Š 0 = no output
1 = output
0
(NC blocks) 6270 - - Š Š Š Š 0 = output in 0.001 mm (1 µm)
1 = output in 0.01 mm (10 µm)
2 = output in 0.0001 mm (0.1 µm)
0
RH
1.0 TNC 407/415 Machine Parameters MP 6210 - MP 6270 16.01.95 10.2 35