Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Kundendienst
HEIDENHAIN
DR JOHANNES HElDENHAlN GrnbH
D~83292Traunreut-~(08669131-0
20. Machine Parameters
SERVICE MANUAL TNC 407/415
Issue: 01.09.1995
Page 108
The following list contains the machine parameters for all software versions. However, as some machine
parameters are not valid for certain controls or have been introduced /eliminated with a certain software
version, columns with symbols for differentiation have been added after the parameter numbers.
Explanation of the Symbols
+
With this control, the machine parameter is valid for all software versions.
04 The machine parameter has been introduced with a certain software version
(e.g. 04 means introduction with software version 04).
IO4The machine parameter has been eliminated starting with a certain software version
(e.g. 04 means elimination as of software version 04). or it has been replaced by another
parameter.
*
This machine parameter is not available on this control.
The machine parameter is accessible via the code number 1’23.
Explanation of the Columns
407 AS Old software 243 07.
415AS Old software 243 05., 259 91.
407 NS New software 243 02.
415 NS New software 259 96.. 259 97.
Structure
The machine parameters are subdivided into groups.
Due to the structure of the parameter numbers, the list can be expanded easily.
0 999 Encoders and machine tool axes: allocation, evaluation, compensation
1000
1400
1700
3000
4000
5000
6000
7100
7200
7320
7330
7400
7600
Positioning
Operation with feed precontrol
Operation with servo lag
Spindle control
Integrated PLC
Adaptation of the data interface
Measurement with 3D-touch probe system
Tapping
Display and programming
Colour allocation for colour screens
User parameters
Processing and program run
Hardware