Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Spindle
Function MP A B C D E F Input AE-6
No. Bit Entry Value
Output of the spindle speed 3010 Š Š Š Š Š Š 0 = spindle speed not output 6
coded 1 = only if speed changes
2 = with every TOOL CALL
analogue 3 = gear switching signal only if gear range
changes
4 = gear switching signal with every
TOOL CALL
5 = no gear switching signal
regulated spindle for orientation 6 = gear switching signal only if gear range
changes
7 = gear switching signal with every
TOOL CALL
8 = no gear switching signal
Output of an analogue voltage at
the analogue output of the spindle
(only if MP3010 < 3)
Feed rate that corresponds to an
analogue voltage of 10V
(only if MP3011 = 1)
3011 -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Š
Š
Š
-
Š
Š
Š
Š
0 = no function
1 = voltage is proportional to the current feed
rate
2 = voltage defined via PLC (module 9130)
3 = voltage defined via M-function
(M200 - M204)
3012 - - - - Š Š 0 to 300 000 [mm/min] 0
RH
1.0 TNC 407/415 Machine Parameters MP 3010 - MP 3012 08.05.95 10.2 18
0