ModuleWare Reference Guide - Hornad

Sequential PartsBank of Latches (latch)Functionlout= rst_val= din= loutif rst is active, elseif oena is activeotherwiseTruth TableTable 8-4. Bank of Latches Truth Tableoena rst lout- 1 rst_val1 0 din0 0 loutParametersTable 8-5. Bank of Latches ParametersParameter Values Defaultdin, lout Port widths (must be > 0) Automaticrst_valrst_typeoena_typeRegister reset value (must be >= 0)ActiveHigh,ActiveLowActiveHigh,ActiveLow0ActiveHighActiveHighDesign Rule Checks• An error is issued if the width of any port cannot be determined or if ports rst, and oena donot have a fixed width of 1.• A warning is issued and HDL generation fails for this part if any of ports are not connected.174ModuleWare Reference Manual, Library Version 1.9September 18, 2008