num parameter manual - Documentation CN

P10 P11 P12 P13 P25 P26 P34 P36
Bits 10 à 8
Select the transmission clock frequency
Bit 10 9 8
0 0 0 :100 KHz
0 0 1 :200 KHz
0 1 0 :400 KHz
0 1 1 :500 KHz
1 0 0 :800 KHz
1 0 1 : 1 MHz
1 1 0 :1.6 MHz
1 1 1 : 2 MHz
Bits 7 à 3
Number of measurement and synchronisation data bits in the frame
Measurement
Examples:
- The Stegmann AG66 SSI encoder transmits the measurement on 12 bits (resolution 4096 pulses per revolution,
single revolution).
The bit codes are: 7 6 5 4 3
0 1 1 0 0
- The Stegmann AG661 SSI encoder transmits the measurement on 24 bits (resolution 4096 pulses per revolution
times 4096 revolutions).
The bit codes are: 7 6 5 4 3
1 1 0 0 0
Bits 2 à 0
Number of status bits transmitted at the end of the transmission frame. These bits must be programmed for use by
bits 19-16.
Example:
The Stegmann AG66 and AG661 SSI encoders transmit a so-called PFB (power failure bit) status bit which is set in
the event of a power failure.
- Bit codes: 2 1 0
0 0 1
! CAUTION
- Linear SSI encoders and combined sensors
- The zero point must be outside the machine travel limits (P17).
en-938818/8 5 - 21
5