num parameter manual - Documentation CN

P10 P11 P12 P13 P25 P26 P34 P36
5.10 Measurement Setting
REMARK: The values can be recorded in the tables of Chapter 3.
Requirements
Emergency stop switch depressed.
CNC on.
Utility 5 displayed on the CNC screen (see 13.2.1).
Action
Set the following parameters:
Declare all the measured axes in P2.
Declare the poor signal check as active on all axes in P25 and P26.
Declare no servo-controlled axes in P3.
Set the Multi/Divi measurement conversion coefficient for each
measured axis.
Enter the computed Multi/Divi values in parameter P11.
Enter the sensor type and parameters in parameter P34.
Enter the graduation and number of graduations in parameter P36.
Exit from utility 5.
Return to the «AXIS» page.
If an error of type 210 to 241 (axis fault) appears on the «AXIS» page:
Check the poor signal error (Pin 7) for the faulty axis.
Check display of the axes on the «AXIS» page.
Only the measurement is displayed.
Measurement
en-938818/7 5 - 25
5