num parameter manual - Documentation CN

13.2.6 Parameter Table Syntax
A parameter table can be created or edited under one of the NUM editors for PC (APA10, NUMPC, PLCTOOL or
SETTOOL). The file created must be saved as an ASCII file.
Proceed as follows to create a table under a PC editor:
Begin the table with the «%» character and end it with «Xoff» (ALT19).
The eight digits following «%» are the job reference of the CNC.
At the end of each line, the two digits after the semicolon indicate the number of characters in the line (including spaces
and «#»). The value is hexadecimal.
Characters PaNb specify the parameter concerned and the first word on the next data line. This is followed by the type
and number of words in the parameter: tcnd (starting at CNC software index K). For instance, P9N0:t0n32 = Parameter
P9, first word on line 0, type 0 and 32 words.
A data line starts with the character «#».
A data line cannot exceed ten values. Parameters with more than ten words must be written on several lines.
13 - 14 en-938818/7