num parameter manual - Documentation CN

13.2.3 Loading a Parameter Table
The table can be loaded from a PC with the NUM software (APA10, NUMPC, PLCTOOL or SETTOOL).
Requirements
«MACHINE SETUP DATA» menu displayed.
Load peripheral on and connected to one of the serial lines of the CPU.
Serial line compatible with the peripheral selected (see Operator Manual).
Actions
Set the peripheral to unload mode.
@
Select «PERIPHERAL LOAD». ☞ 2
The cursor moves to line 2 and the message «READY?» is displayed on the dialogue line.
Enter. ☞ Y
Start unloading from the peripheral.
If the identification number of the parameter table to be loaded does not correspond to the job reference of the CNC,
transmission is stopped and the identification number is displayed on the dialogue line.
Replace the identification number by the job reference. ☞
Transmission is resumed.
13 - 10 en-938818/4