num parameter manual - Documentation CN

List of Machine Parameters
2 List of Machine Parameters
Parameter Category Type Description See page
P0 Axis declaration 6 Displayed axes 4-10
P1 Axis declaration 6 Modulo and limited excursion rotary axes 4-12
P2 Axis declaration 6 Measured axes 4-8
P3 Axis declaration 6 Servo-controlled and interpolated axes 4-14
P4 Axis declaration 0 Axes programmed by diameter 4-18
Internal system measurement
P5 Axis declaration 0 Axis group machine configuration 4-16
Lathe or milling machine groups
Front/Rear turrets
P6 Spindles 0 Number of controlled spindles 8-10
Spindle type
Spindle assignments to axis groups
P7 Miscellaneous 0 Initialisation in inches or metric units 9-6
Direction of automatic spindle search
Transmission of T and M functions to the machine
processor in SEARCH and TEST modes
Forcing of T functions
Interaxis calibration table enable
Initialisation in G94 or G95
Forcing of manual mode
Homing selection
Subroutine call on reset
Feed stop with rigid tapping
Speed variation with gradual acceleration
P8 Axis declaration 6 Axes with clamps 4-22
P9 Axis declaration 0 Axis assignment to groups 4-24
P10 Measurements 6 Axis measurement direction 5-4
P11 Measurements 5 Axis measurement conversion coefficient 5-6
P12 Measurements 0 Direction of handwheel measurement 5-10
P13 Measurements 5 Handwheel measurement conversion coefficient 5-12
P14 Axis declaration 0 Handwheels 4-28
P15 Axis travel 6 Direction of homing 7-8
Switch status test
P16 Axis travel 2 Reference switch position in machine dimensions 7-10
P17 Axis travel 2 Axis travel limit 7-12
P18 Axis travel 1 Reversal error compensation 7-14
P19 Servo-control 1 Very high speed machining 6-34
P20 Servo-control 6 Direction of axis speed reference 6-12
P21 Servo-control 4 Servo-system loop gain coefficient 6-14
P22 Servo-control 5 In-position window 6-20
P23 Servo-control 4 Maximum following error 6-22
P24 Servo-control 5 Synchronised axis control 6-30
P25 Measurements 6 Poor signal and encoder channel 5-14
complementarity check declaration
P26 Measurements 0 Poor signal and encoder channel 5-16
complementarity check
P27 Axis declaration 0 Duplicated axis coupling definition 4-30
P28 Axis declaration 6 Synchronised axis coupling enable 4-32
P29 Gear cutting 1 Reserved for NUM 1060 HG gear cutting Not documented
en-938818/7 2 - 1
2