num parameter manual - Documentation CN

Table of Contents
Table of Contents
1 Parameter Definition 1 - 1
1.1 Introduction 1 - 3
1.2 Rules for Writing the Parameters 1 - 3
1.3 PLC Variable Mnemonics 1 - 5
2 List of Machine Parameters 2 - 1
3 Order of Parameter Integration 3 - 1
3.1 Axis Declaration 3 - 3
3.2 Measurement Settings 3 - 8
3.3 Servo-Control Settings 3 - 11
3.4 Setting of Travels 3 - 20
3.5 Spindle Settings 3 - 23
3.6 Miscellaneous Parameters 3 - 28
3.7 Communication Parameter Settings 3 - 31
3.8 DISC Axis Parameter Settings 3 - 33
4 Axis Declaration 4 - 1
4.1 Data Tables 4 - 3
4.2 Number of Axis Groups in the System 4 - 6
4.3 Measured Axes 4 - 8
4.4 Displayed Axes 4 - 10
4.5 Modulo or Limited Excursion Rotary Axes 4 - 12
4.6 Servo-Controlled and Interpolated Axes 4 - 14
4.7 Axis Group Machine Configuration 4 - 16
4.8 Axes Programmable by Diameter and
Internal Measurement 4 - 18
4.9 Axes with Clamps 4 - 22
4.10 Axis Assignment to a Group 4 - 24
4.11 Handwheel Declaration 4 - 28
4.12 Coupling Assignment for Duplicated and
Synchronised Axes 4 - 30
4.13 Synchronised Axis Coupling Enable 4 - 32
4.14 Carrier or Carried Axes 4 - 34
4.15 Axes with Quantified Movements 4 - 36
5 Measurement 5 - 1
5.1 Data Tables 5 - 3
5.2 Axis Measurement Direction 5 - 4
5.3 Axis Measurement Conversion Coefficient 5 - 6
5.4 Handwheel Measurement Direction 5 - 10
5.5 Handwheel Measurement Conversion
Coefficient 5 - 12
5.6 Poor Signal and Encoder Channel
Complementarity Check Declaration 5 - 14
5.7 Poor Signal and Encoder Channel
Complementarity Check 5 - 16
5.8 Definition of Measurement Sensor Type
and Parameters 5 - 18
en-938818/7 3