num parameter manual - Documentation CN

1.2.3 Decimal Words
Parameter types 1, 2, 4 and 5.
Each word contains a signed or unsigned decimal value.
Parameter Definition
! CAUTION
When entering the values, comply with the units specified for each type of word.
1.2.4 ASCII Character String
Parameter type 8.
Each word contains an ASCII character string.
! CAUTION
When entering the values, comply with the maximum number of characters.
1.3 PLC Variable Mnemonics
The table below gives the addresses of the PLC variables corresponding to the mnemonics mentioned in this manual.
Mnemonic Identification Assembler Ladder
CRM M function report A.10E
CRM1 Group 1 M function report %W100.5
CRM2 Group 2 M function report %W200.5
CRM3 Group 3 M function report %W300.5
CRM4 Group 4 M function report %W400.5
CRM5 Group 5 M function report %W500.5
CRM6 Group 6 M function report %W600.5
CRM7 Group 7 M function report %W700.5
CRM8 Group 8 M function report %W800.5
POSBR1 Spindle 1 in position E.11E %R13.0
POSBR2 Spindle 2 in position E.11F %R13.1
POSBR3 Spindle 3 in position %R13.2
POSBR4 Spindle 4 in position %R13.3
CN_PRET CNC ready E.108 %R5.0
V_REDUIT Low speed A.111 %W4.7
VITMAN1 JOG 1 selection A.109 %W4.1
VITMAN2 JOG 2 selection A.10A %W4.2
en-938818/5 1 - 5
1