num parameter manual - Documentation CN

9.6 Interaxis Calibration Table and Programme Stack P58
Reservation
Description
9 - 14 en-938818/6
Category Miscellaneous
Type 5 Unsigned decimal
No. of words 2
Used to allocate the interaxis calibration table and specify the programme stack size.
Principle
Word N0
Used to allocate the interaxis calibration table.
Defines the number of parameters from E81000 to E81999 «Master axis reference positions» and E82000 to E82999
«Slave axis corrections».
The parameters are reserved by increasing order from E81000 to E81xxx and E82000 to E82xxx.
The value entered must be less than or equal to 1000.
REMARK: If a value higher than 1000 is entered, the system automatically limits the number
of parameters to 1000.
Word N1
Used to reserve the programme stack size for the graphic group and axis groups.
The value entered corresponds to the size in word (2 bytes) for one group. The minimum stack size must be above
10 kbytes.
REMARK: The total programme stack size is displayed on the «DIR.» page.
Example
Word 0 200
Parameters E81000 to E81199 and E82000 to E82199 can be used.
Word 1 20480
The programme stack has a size of 40 kbytes.