num parameter manual - Documentation CN

P97 P2 P0 P1 P3 P5 P4 P8 P9 P14 P27 P28 P64 P65
Axis Declaration
On the number of groups declared, the system chronologically assigns the CNC groups starting with the first axis group
(group 1) then the PLC axis groups after the last CNC axis group.
Programme Parameter (see «Part Programming Manual»).
Programme parameter E41102 is used to read the number of CNC axis groups.
Example
The system controls three CNC axis groups and two PLC axis groups.
Word N0 03
Word N1 02
The groups are assigned as follows:
Group number CNC PLC
Group 1 X
Group 2 X
Group 3 X
Group 4 X
Group 5 X
Group 6 Unassigned
Group 7 Unassigned
Group 8 Unassigned
en-938818/7 4 - 7
4