num parameter manual - Documentation CN

OPERATION LINE SELECTED COMMAND MODULE
SYNTAX CONCERNED
Move the cursor one character left on
the dialogue line
Dialogue line
Change
Move the cursor to the end of the dialogue Dialogue line SHIFT ➞ line
Change
Move the cursor to the beginning of the
dialogue line
Dialogue line SHIFT➞
Change
Delete the dialogue line Dialogue line Change
Delete the character to the left Dialogue line Change
of the cursor
13.2.2.2 Displaying Parameters
The parameter editor is used to display the machine parameters.
Requirements
«MACHINE SETUP DATA» menu displayed.
Actions
)
Select « DISPLAY». ☞ 0
«PARAMETER?» is displayed on the dialogue line.
Enter the command corresponding to the operation to be
performed (see table below).
13 - 6 en-938818/4
OPERATION COMMAND SYNTAX
Display P0 or .../... or Pg Dn
Display any parameter P [n]
where [n] is the parameter number
Select a word in a parameter P [n]_N [n]
➞
where [n] is the parameter number and the word number