num parameter manual - Documentation CN

13.2.5 Check of a Parameter Table Unloaded Into a Peripheral
Parameter Integration Tool
After unloading a parameter table into a peripheral, it is necessary to check that the data saved are the same as the
initial data.
Requirement
Peripheral ready to send the data saved.
«MACHINE SETUP DATA» menu displayed.
Actions
Set the peripheral to unload mode.
$
Select «VERIFY» ☞ 4
The cursor moves to line 4 and the message «READY?» is displayed on the dialog line.
Enter. ☞ Y
Run the unload procedure on the peripheral side.
The parameters are listed on the CNC screen by increasing order, preceded by «(VERI)».
At the end of the check, if no errors were detected, the «MACHINE SETUP DATA» menu is redisplayed with the cursor
on item 0, «DISPLAY».
Otherwise, the system stops on the parameter with an error and the message «FILE ERROR» (INCORRECT TAPE?)
is displayed on the dialog line. Repeat the table unload procedure (see 13.2.4). If the error persists, check the link
between the CNC and the peripheral and the communication parameters.
en-938818/4 13 - 13
13