num parameter manual - Documentation CN

P7 P35 P50 P51 P58 P59 P80 P95 P96 P98 P99 P114
Word N1
Bit 7
Programme Parameter
Bit 0
Miscellaneous Functions
Choice of feed rate programming unit.
If this bit equals 1, the system is initialised in mm/rev (G94).
If this bit equals 0, the system is initialised in mm/min (G95).
Forcing of MANUAL mode.
If this bit is a 1, miscellaneous function M12
forcing the MANUAL mode is processed.
Homing selection
If this bit is a 0, homing from the keyboard is enabled.
If this bit is a 1, homing from the keyboard is inhibited.
Subroutine call on a reset
If this bit is a 1, subroutine call on a reset is enabled.
Feed stop for rigid tapping
If this bit is a 0, detapping is commanded before
reaching the hole bottom.
If this bit is a 1, feed stop is inhibited during the
tapping phase; where applicable, the system is
in Feed Stop state at the end of the cycle.
Speed variation in S
If this bit is a 0, linear speed variation is enabled.
If this bit is a 1, gradual acceleration is enabled.
G52 prohibited when an inclined plane is valid.
If this bit is a 0, programming an inclined plane axis
in G52 returns error 24.
If this bit is a 1, programming an inclined plane axis
in G52 is enabled.
Programme parameter E11013 enables speed variation in S. At power on, E11013 is set to the value of bit 5 of word
N1. This programme parameter is not reset by a reset.
en-938818/6 9 - 7
9