num parameter manual - Documentation CN

If the following error is not corrected:
Check that the servo-drive reference voltage is equal to 9 V.
Adjust the servo-drive scale setting if necessary using the
potentiometer provided.
Suspend execution of the program.
Modify the program by programming the maximum speed on the axis.
Rerun the program.
The following error should stabilise at (VMAX x Τ) and not reach the limit set in parameter P23.
If an error number 40 to 71 «Following error too large on the axis» is displayed before the limit set in P23:
Check the setting of parameter P56.
If the speed reference is not saturated at 10 V:
Recompute the setting of P23.
11 - 4 en-938818/4
! CAUTION
If these settings do not affect operation on the system, the maximum speed required can
probably not be reached (mistake in manufacturers data, problem with the motor, servodrive
power supply voltage, etc.).