num parameter manual - Documentation CN

6.3 JOG Speeds and Reduced Speeds P31
6 - 8 en-938818/7
Category Servo-control
Type 4 Unsigned decimal
No. of words 5
Description
Used to define the speeds corresponding to manual mode and the reduced speeds requested by the machine
processor.
Principle
Words N0 to N2
Words N0 to N2 define the speeds of movement on the axes:
- slow JOG for N0,
- normal JOG for N1,
- fast JOG for N2.
The speeds are expressed in mm/min.
They can be overridden by the feed rate potentiometer.
The normal and fast speeds are accessible from the machine panel.
Words N3 and N4
Words N3 and N4 are used to set the parameters of the reduced speeds requested by the PLC function
(VREDUCT = 1).
Word N3 gives the reduced speed on linear axes in mm/min.
Word N4 gives the reduced speed on rotary axes in deg/min.