num parameter manual - Documentation CN

Word N2
Sets the turnaround time (as a number of characters). The default value is $1.
The turnaround time is the minimum time that a unit must wait before beginning to send a message to allow the remote
unit to turn around (switch from transmission to reception). The minimum time that can be set is the time required to
send one character.
For further details, refer to the drawing in Section 10.6.
Word N3
Sets the server slave number. The default value is $0.
Word N4
Specifies the client slave number. The default value is $0.
Destination Address of the Unsolicited Data
The next five bytes define the series 7 destination address to which unsolicited data are sent.
Reminder
Unsolicited data are messages which can be sent by:
- A part programme (instruction $n). This instruction is described in detail in the programming manual, or
- The operator from the panel in the Communication page, "Operator Messages" menu, "Network messages" page
(refer to the Operator Manual).
Word N5
Defines the destination network number.
Word N6
Defines the destination station number.
Word N7
Defines the destination port number.
Word N8
Defines the destination module number.
Word N9
Defines the destination channel number.
REMARK: Encoding of a series 7 address is described in Chapter 5 of the UNI-TELWAY
Integration Manual.
10 - 18 en-938818/8