num parameter manual - Documentation CN

4.7 Axis Group Machine Configuration P5
Description
Used to define the machine configuration:
- lathe and milling machine groups,
- front and rear turrets.
Principle
Each bit represents the address of an axis group.
4 - 16 en-938818/7
Category Axis declaration
Type 0 8-bit hexadecimal
No. of words 2
Group 8
Bit 7
Group 7
Group 6
Word N0: configuration of the initial programming functions and definition of the graphic display types.
A bit is a 0 to define a lathe group or a 1 to define a milling machine group.
Word N1: milling machine group assignment.
A bit is a 0 for a rear turret or a 1 for a front turret.
Group 5
Programme Parameter (see «Part Programming Manual»).
Programme parameter E11016 is used to enable the front turret or rear turret by programming. A reset (CNC INIT)
sets this parameter to the state of word N1 of P5.
Example
Setting the parameters for the following machine configuration.
Group 1 2 3
N0 Lathe Lathe Milling machine
N1 Rear Front
turret turret
Group 4
Group 3
Group 2
Group 1
Bit 0