num parameter manual - Documentation CN

6.8 In-Position Window P22
6 - 20 en-938818/7
Category Servo-control
Type 5 Unsigned decimal
No. of words 32
Description
A distinction is made between two cases:
For stopping an axis at the end of movement, defines the following error threshold below which the CNC considers
the movement to be finished.
At the end of a block including function G9, defines the following error threshold below which the CNC considers the
movement in the block to be finished.
Principle
Each word corresponds to the physical address of an axis.
- The value in word N0 is assigned to the axis with physical address 0,
- The value in word N1 is assigned to the axis with physical address 1,
- The value in word N2 is assigned to the axis with physical address 2,
- etc.
Physical List of
axis @ words
@0 Word N0
@1 Word N1
' '
' '
' '
@31 Word N31