num parameter manual - Documentation CN

13.2.2 Using of the Editor
13.2.2.1 Using the Commands
Parameter Integration Tool
The two editor modules contain commands used to move around in the parameter pages and modify the parameter
values.
Requirements
Parameter to be checked or edited displayed on the screen.
Actions
Enter the command corresponding to the operation
(see table below).
OPERATION LINE SELECTED COMMAND MODULE
SYNTAX CONCERNED
Display of the parameters Any word P [n]
where [n] is the
parameter number
Display
Change
Select a word in a parameter Any word P [n]_N [n]
where [n] is the parameter
number and word number
Display
Change
Display the next parameter Any word or .../... Display
Change
or Pg Dn
Move the cursor to the next word Previous word
➞
Display
Change
Move the cursor to any word Any word N [n]
where [n] is the
word number
Display
Change
Display the value of a word on the
dialogue line
Word to be edited SHIFT
#
3
Change
Edit the value of a word Word to be edited SHIFT
# + Change
[Value]
Edit a string of words (maximum 10
consecutive values)
First word to be
edited
SHIFT
[String]
3
#
3
+ Change
Move the cursor one character right on Dialogue line ➞ Change
the dialogue line
en-938818/4 13 - 5
13