num parameter manual - Documentation CN

13.2.4 Unloading a Parameter Table
The parameter table can be unloaded to a PC via the RS232 link using the NUM software (APA10, NUMPC, PLCTOOL
or SETTOOL).
Requirements
«MACHINE SETUP DATA» menu displayed.
Load peripheral on and connected to one of the serial lines of the CPU.
Serial line compatible with the peripheral selected (see Operator Manual).
Actions
Set the peripheral to load mode.
#
Select «PERIPHERAL UNLOAD». ☞ 3
The cursor moves to line 3 and the message «READY?» is displayed on the dialogue line.
Enter ☞ Y
The CNC job reference (%nnnnnnnn) is displayed on the dialogue line.
You may enter a comment after the job reference.
You can also edit the job reference.
Start the unload procedure on the CNC side.
Start the load procedure on the peripheral side. ☞
The parameter table is unloaded with a return to the «MACHINE SETUP DATA» menu at the end of the operation.
13 - 12 en-938818/4