num parameter manual - Documentation CN

13.2.2.3 Editing Parameters
The parameter editor is used to edit the machine parameters.
Requirements
«MACHINE SETUP DATA» menu displayed.
Actions
!
Select «CHANGE». ☞ 1
«PARAMETER?» is displayed on the dialogue line.
Enter the command corresponding to the operation to be
performed (see table below).
13 - 8 en-938818/4
OPERATION COMMAND SYNTAX
Display P0 or .../... or Pg Dn
Display any parameter P [n]
where [n] is the parameter number
Select a word in a parameter P [n]_N [n]
The display page for the parameter selected is displayed (P9 in the example).
(CHANG) PARA: 9 NB WORDS: 32 TYPE: 0
(BIN. BYTE)
>N 0 00
N 1 02
N 2 08
N 3 10
N 4 11
. . / . . EXIT
The «PARA» field gives the parameter number.
The «TYPE» field gives the parameter type (see 1.2).
where [n] is the parameter number and the word number