Operator Terminal System Manual - 11276916.pdf

System Manual – DOP11A Operator Terminals
Programming
Programming with the programming software
[Setup] menu The [Setup] menu includes functions for configuring the terminal.
10433AEN
System signals With this option you can define handshake signals between terminal and controller.
Current display register
Data register in the controller that contains the number of the block (in run mode) to be
displayed on the screen. The data register is automatically updated when the block is
changed. This register does not affect block selection.
New display register
Data register in the controller that defines which block will be displayed on the screen.
Buzzer register
Not applicable for DOP11A-10.
The value of this register defines the buzzer tone. Tones and scales are given in the
table below. Value 0 means there is no tone. All values in the table are given in Hz.
C D E F G A H
Contra 33 37 41 44 49 55 62
Large 65 73 82 87 98 110 123
Small 131 147 165 175 196 220 247
One 262 294 330 349 392 440 494
Two 523 587 659 698 784 880 988
Three 1046 1174 1318 1397 1568 1760 1975
Four 2093 2348 2636 2794 3136 3520 3950
Five 4186
I
0
7
103