Operator Terminal System Manual - 11276916.pdf

System Manual – DOP11A Operator Terminals
Programming
Programming with the programming software
Positioning objects The [Layout] menu offers several functions for easily positioning objects:
Align
Make same size
Space evenly
Tile
You can also invoke these functions from a separate toolbox.
This function can only be invoked when at least two objects have been selected. The
functions perform their positioning calculations based on one or two reference objects.
The functions [Align], [Make same size] and [Tile] refer to the object that was last
selected or created. See the section "Selecting several objects" on page 80.
The function [Space evenly] takes the object furthest down to the bottom/top or left/right
as reference object. The functions do not affect the reference object.
Figure 41: [Layout] menu
10414AEN
Align
The [Align] function offers six menu options for aligning objects vertically or horizontally.
Left Aligns the selected objects flush left with the reference object.
Right Aligns the selected objects flush right with the reference object.
Top Aligns the selected objects flush with the top of the reference object.
Bottom Aligns the selected objects flush with the bottom of the reference object.
Vertical center Centers the selected objects vertically based on the reference object.
Horizontal center Centers the selected objects horizontally based on the reference object.
I
0
7
85