Operator Terminal System Manual - 11276916.pdf

System Manual – DOP11A Operator Terminals
Programming
Programming with the programming software
Delete Use [Delete] to delete a symbol from a project.
Add a static
symbol to a block
Click [Symbol] in the toolbox and move the cursor over the block in the work area where
you want to place the symbol. Next, make a mouse click. Clicking on the work area
opens the [Static symbol] dialog.
Figure 46: Static symbol
[General] tab
10421AEN
Parameter Description
Symbol Select the symbol you want to display.
Use dynamic bitmaps For DOP11A-50 only
Resizable If this option is enabled, you can change the x or y size of the
object.
Other tabs
The functions on the [Dynamics] tab are described in the section "General parameters"
in chapter 7.4 "Graphic display and control".
I
0
7
93