Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Index addressing
0
10450AEN
Torque and speed and displayed in the form of two numeric objects. In the object for the
torque, "D100" is defined as analog signal and "I1" as index register.
10451AEN
In the object for the speed, D200 is defined as analog signal and I1 as index register.
The maneuverable multiple selection object allows for calling up the motor 1, motor 2,
and motor options in run mode. The values 1, 2 or 3 are stored in register D0 depending
on what you have selected. The value in register D0 is added to the addresses of the
objects that display torque and speed. Consequently, the object can display the values
of register D101, D102 or D103, or register D201, D202 or D203.
180 System Manual – DOP11A Operator Terminals