Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Graphic display and control
0
Event
10597AEN
Under the [Event] tab you can define the parameters described below. You can update
existing events, add new events or delete events by clicking the corresponding buttons
in the dialog box.
Parameters Description
Event name Enter a name for the event or select an entry from the list.
Condition Select a condition from the list. You can choose between four conditions:
Equal to The event will be triggered after the specified signal where the object
value corresponds with the value you have defined in the value checkbox.
The value has to be entered by the user.
Not equal to The event will be triggered after the specified signal where the object
value does NOT correspond with the value you have defined in the
value checkbox. The value has to be entered by the user.
Greater
than
The event will be triggered after the specified signal where the object
value is greater than the value you have defined in the value checkbox.
The value has to be entered by the user.
Less than The event will be triggered after the specified signal where the object
value is smaller than the value you have defined in the value checkbox.
The value has to be entered by the user.
Action Select one of the following options:
Digital signal
Analog signal
Macro
Signal Select the signal that will be influenced if the condition is fulfilled.
Value Enter the value for the affected signal if the condition is fulfilled.
124 System Manual – DOP11A Operator Terminals