Operator Terminal System Manual - 11276916.pdf

Installation
4 Connection to a PC
4.4 Connection to a PC
DOP 11A-10, DOP11A-20
& DOP11A-40 DOP 11A-30
Voltage supply DOP11A-10 to DOP11A-40 Voltage supply DOP11A-50
(AC 100 - 240 V)
53031AXX 53630AXX
[1] Ground
[2] 0 V
[3] +24 V
[1] [2] [3] [3] [2]
Figure 9: Connection to a PC
PCS11A
RS-232 RS-232
Programming of the operator terminal takes place via the HMI-Builder software.
You need the PCS11A communication cable to program the operator terminal.
24 System Manual – DOP11A Operator Terminals
[1]
DOP11A
The power must be switched off when connecting the units.
DOP 11A-50
[1]
53040AXX