Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Programming with the programming software
0
The terms used for defining the block header are explained below:
Block no.
The block number is specified in this field. If the entered number was already assigned
to a block, the defined values will appear automatically. Block number 0 is automatically
created at the start and must exist in every project.
Block name
You can enter a name for the block in this field. The block name is listed in the block list.
Display signal
Digital signal that displays the selected block on the terminal screen. Use display signals
in series to change blocks as quickly as possible. No entry is made in this field if you use
another block changing method.
Print signal
Digital signal that sends the block to the connected printer. Display and print signals can
be identical. Use print signals in series for fastest possible printing.
Completion signal
Digital signal that is output by the terminal when the print process has been completed.
The signal is enabled by default. Selecting the [Reset] option resets the signal when the
print process has been completed.
Recipe directory
Select a recipe directory where all recipes created in the block will be stored.
Send mail signal
When the specified digital signal is enabled, the text block will be sent as e-mail. The
block name corresponds to the subject of the e-mail.
Only text blocks can be sent as e-mail.
Mail completion signal
Digital signal that is output by the terminal after an e-mail has been sent. The signal is
enabled by default. Selecting the [Reset] option resets the signal when the e-mail has
been sent.
76 System Manual – DOP11A Operator Terminals