Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Graphic display and control
0
screen. If you touch two spots at the same time, the spot between the two spots you
have touched will be chosen.
When using terminals with touchscreen, objects CANNOT be controlled in the text
block.
If you touch a non-maneuverable object, the message "Not maneuverable" will appear.
If you touch a password protected object, the message "Access denied" will appear.
Digital objects Digital objects, text objects, symbol objects and filled objects change their state when
you touch them with your finger.
Analog objects ASCII objects
To select an object on the screen, touch it with your finger. This displays an alphanumeric
keyboard on the screen. Enter the required text by touching the keyboard.
Complete your entry by pressing the Enter key.
Multiple selection objects
Touch the object with your finger to open a selection list. To select an object on the
screen, touch it with your finger.
Numeric objects
Touch the object with your finger. The numeric keyboard will be displayed. Enter the
required value by touching the keyboard. Complete your entry by pressing the Enter key.
Numeric table objects
Touch a cell in the table object with your finger. The numeric keyboard will be displayed.
Enter the required value by touching the keyboard. Complete your entry by pressing the
Enter key.
Slider objects
Control the object by touching and then dragging the buttons.
Bar graph objects
Touch the bar to reset the minimum / maximum indicators.
156 System Manual – DOP11A Operator Terminals