Operator Terminal System Manual - 11276916.pdf

Operating
graphic blocks
Selecting maneuverable
objects
System Manual – DOP11A Operator Terminals
Programming
Graphic display and control
Other tabs
The functions on the [Access] and [Dynamics] tabs are explained in section "General
parameters" on page 114.
Commands for TCP/IP command prompt
Command Description
IPCONFIG Retrieves and displays the current IP address for the terminal.
PING Checks whether a value is available.
ROUTE Serves to display, add and delete routes.
ARP Serves to display, add and delete IP hardware addresses.
For further information on TCP/IP networks, refer to chapter 9.2 "Network
communication".
Not applicable for DOP11A-30 and DOP11A-50.
Press the arrow keys to change between maneuverable objects. A selected object is
identified by a blinking border.
Press the arrow keys to change between maneuverable objects. The object is selected
according to the following principle:
The cursor is positioned in the middle of a cross. Pressing the right arrow key selects
the first object located in area "A" (see figure). If the system does not find an object in
the narrow area on the right side, it will browse area "a". Pressing the down arrow key
searches for objects in areas "B" and "b". Press the left arrow key to search in areas "C"
and "c". Press the up arrow key to search objects in areas "D" and "d".
x = cursor position
c D d
C
x
b a
B
A
53964AXX
I
0
7
153