Operator Terminal System Manual - 11276916.pdf

System Manual – DOP11A Operator Terminals
Programming
Creating a project
The application is built up of blocks, graphic blocks and /or text blocks (primarily for
report printouts). Values from the controller system are shown and changed in the
blocks. Each block has a number between 0 and 989 allocated by the programmer. The
blocks 990-999 are reserved for special purposes, so-called system blocks. The terminal
is object oriented, which means that a block can contain all the signals linked to an
object for the control and monitoring of, for example, a pump.
Configuration mode Run mode
Level 1
Level 2
Level 3
Controller selection
System signals
Index register
Language
Figure 25: Configuration mode and run mode
Block n
Block 0
53376AEN
I
0
7
55