Operator Terminal System Manual - 11276916.pdf

I
Startup
5 Operator terminal functions
0
Switches on
DOP11A-30 and
DOP11A-50 terminals
RUN and SETUP
operating modes
Interrupt power supply to terminal to call up individual modes for DOP11A-30 and
DOP11A-50.
Turn the rotary switch on the side or back of the terminal to the position shown in the
following table. You can now turn on the power supply once again.
The terminal has two operation modes.
Configuration mode (SETUP): All basic settings are made in this mode, such as
selection of controller system and menu language.
Run-time mode (RUN): This mode is for running the application.
Transfer Here you manually set the terminal to transfer mode. When the terminal is in transfer
mode it is possible to transfer projects between the terminal and the programming software.
By using the automatic terminal switching function [RUN] / [TRANSFER] in the
programming software, the software automatically sets the terminal to transfer mode.
Switching between
modes
Switch position Function
0 Run mode (RUN, standard operation)
1 Sysload
2 Calibrate touch
3 Cursor
4 Configuration mode (SETUP)
5 Transfer mode, TRANSFER
8 Activates self-test function
9 Erases the clock memory
Switch between RUN and SETUP
Press and simultaneously to enter configuration mode (SETUP). You can
now press any key when the start-up menu is shown to enter the configuration mode,
SETUP. To return to run mode, press and .
In DOP11A-30 and DOP11A-50 you set the switch on the side/back of the terminal in
position 4 to access the configuration mode (Setup). The switch should be in position 0
for standard operation.
38 System Manual – DOP11A Operator Terminals