Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Transferring projects
0
Modem settings Use the following settings for the modem connected to the operator terminal:
AT &F E0 Q1 &D0 &K0 &W
Use the following settings for the modem connected to the PC:
AT &F &D0 &K0 &W
The modem commands are described in the following table.
Command Description
AT Tells the modem that it will receive commands.
AT precedes all commands.
&F Resets the modem to factory defaults.
&E0 Deactivates echo.
Q1 Result codes are not returned.
&D0 Modem ignores DTR.
&K0 No flow control.
&W Saves settings.
The modem must be set to "autoanswer" to enable transfer.
168 System Manual – DOP11A Operator Terminals