Operator Terminal System Manual - 11276916.pdf

7.6 Transferring projects
Setting up your
terminal
System Manual – DOP11A Operator Terminals
Programming
Transferring projects
Multiple selection objects
To operate a multiple selection object, move the cursor with the arrow keys to the required
object and press the Enter key. This displays a selection list with all available
states on the screen. Select the required state and press the Enter key. The analog signal
linked to the object will be changed.
Jump objects
Select the required object and press the Enter key.
Bar objects
You can set the indicators for the minimum and maximum values to the current value for
the bar object. To do so, select the object and press the Enter key.
To make the project available to the terminal, you have to transfer the project from the
PC (where it was programmed) to the terminal.
Connect the PC on which the HMI-Builder is installed to the terminal using the PCS11A
cable.
The terminal parameters usually need not be set. The project transfer is controlled by
the HMI-Builder. If required, you can set the transfer parameters in the terminal in
configuration mode under [Setup] / [Port parameters] / [HMI-Builder].
The communication settings for HMI-Builder and terminal must be identical.
I
0
7
163